I wanted to cover off a couple of important updates in this post relating to the DELL PERC storage controller Firmware and software drivers as well as an important new release of ESXi 6.0 that addresses a couple of issues with VSAN and also fixes to more VMXNET3 problems which seem to keep popping up. […] Read More
Dell PowerEdge FX2: VSAN Disk Configuration Steps
When you get your new DELL FX2s out of the box and powered on for the first time you will notice that the disk configuration has not been setup with VSAN in mind…If you where to log into ESXi on the blades in SLOT1a and 1c you would see that each host will have each SAS […] Read More
VSAN + DELL PERC: Important Driver and Firmware Updates
I’m currently going through and documenting the build process for our VSAN Management Clusters and one of the first steps I noted down was to double check that the I/O Controllers where compatible as per the VSAN HCL. As I am using the DELL FX2s I checked to ensure that there where no issues with the FD332-PERC […] Read More
Dell PowerEdge FX2: CMC Configuration Gotchya
Back in September I wrote an introductory post (If you haven’t read that post click here) on the DELL PowerEdge FX2 HCI hardware and why we had selected it for our VSAN Management platform. After a busy two months consisting of a VMworld, vForumAU and VeeamOn it’s finally time to put start working towards putting these babies into production. […] Read More
First Look: Dell PowerEdge FX2 Converged Platform
For the last six months or so I’ve been on the look out for server and storage hardware to satisfy the requirement for new Management Clusters across our Zettagrid vCloud Zones… After a fairly exhaustive discovery and research stage the Dell PowerEdge FX2 dropped at the right time to make the newly updated converged architecture […] Read More